UNI EN 1992-4:2018 | Eurocodice 2 - Progettazione delle strutture di calcestruzzo - Parte 4
Eurocodice 2 - Progettazione delle strutture di calcestruzzo - Parte 4: Progettazione degli attacchi per utilizzo nel calcestruzzo
La norma fornisce un metodo di progettazione per gli attacchi (collegamento di elementi strutturali e non strutturali a componenti strutturali) utilizzati per trasmettere azioni al calcestruzzo.
Data entrata in vigore: 22 novembre 2018
Recepisce: EN 1992-4:2018
UNI CEN/TS 1992-4-5:2009
UNI CEN/TS 1992-4-1:2009
UNI CEN/TS 1992-4-2:2009
UNI CEN/TS 1992-4-3:2009
UNI CEN/TS 1992-4-4:2009
In allegato Preview EN 1992-4:2018 riservato Abbonati
EN 1992-4:2018 Eurocode 2 - Design of concrete structures - Part 4: Design of fastenings for use in concrete
This European Standard provides a design method for fastenings (connection of structural elements and non-structural elements to structural components), which are used to transmit actions to the concrete. This design method uses physical models which are based on a combination of tests and numerical analysis consistent with EN 1990:2002, 5.2. Additional rules for the transmission of the fastener loads within the concrete member to its supports are given in EN 1992-1-1 and Annex A of this EN. Inserts embedded in precast concrete elements during production, under Factory Production Control (FPC) conditions and with the due reinforcement, intended for use only during transient situations for lifting and handling, are covered by CEN/TR 15728.
This EN is intended for safety related applications in which the failure of fastenings may result in collapse or partial collapse of the structure, cause risk to human life or lead to significant economic loss. In this context it also covers non-structural elements.
The support of the fixture can be either statically determinate or statically indeterminate. Each support can consist of one fastener or a group of fasteners.
This EN is valid for applications which fall within the scope of the EN 1992 series. In applications where special considerations apply, e.g. nuclear power plants or civil defence structures, modifications can be necessary.
This EN does not cover the design of the fixture. Rules for the design of the fixture are given in the appropriate Standards meeting the requirements on the fixture as given in this EN.
This document relies on characteristic resistances and distances which are stated in a European Technical Product Specification (see Annex E). At least the characteristics of Annex E are given in a European Technical Product Specification for the corresponding loading conditions providing a basis for the design methods of this EN.